cubby boxes and utility storage...
For our FULL RANGE of Cubby Boxes and other Vehicle Storage, please go to the 'Brochures' Section and view 'Vehicle Utility Storage'
Our Cubby Boxes are constructed in polypropylene and are lightweight but very resilient. Originally designed for the Defender range of Land Rovers, they have also been fitted to Series vehicles, and produced as one-offs to meet customer's individual requirements. They provide basic no nonsense storage.
Prices shown are excluding VAT and excluding Carriage
The Nav-Box in Action
The Nav Box
- UC-NBT: Twin wall
-
This unit is designed to house a Laptop computer connected to a GPS system. Recommended fitting is via our mounting plate into the front mid seat runners and locating holes in a Defender 90/110 or straight to the floor as space permits. This unit comes fitted with a carry handle to allow easy transport outside of vehicle.
UC-NBT Length Width Height Weight Price Box 430mm 315mm 155mm 2.44kg P.O.A No Tray - - - - -
Fitting the boxes
- UC-MP: mounting plate
-
The easiest way to install and remove any of our boxes in Defender 90 / 110 vehicles is to use the mounting plate UC-MP which fits in place of the mid front seat squab (see comments below RE: locating pins.) For permanent installation of the larger single and twin wall units the back of the mid seat needs to be removed just above the cross bracket leaving the seat squab locating holes and seat runners in place.
In later vehicle models the electronics fitted to the underside of the seat squab may need to be relocated to the floor panel.
Length Width Height Weight Price 457mm 300mm 50mm 4.1kg £38 Please note that the locating pins on the mounting plate have been designed to fit most Land Rover mid seats at 165mm (6.5") centres. However, some seat locating pins are centred more widely; additional holes can be drilled in the cross bracket to accommodate our mounting plate as well as the seat.
Alternatively, the box could be bolted straight through the floor.